Mesa Water Heater Odor Repair

Are you experiencing a difficulty with stinky odors originating from the water coming from your water heater? It could happen at times for a couple various reasons. Here is what Water Heater Repair Mesa AZ recommends to do to make sure your water smells considerably better and to remove any undesirable taste quickly.

Causes for Mesa Water Heater Odors?

Bacteria getting into the water system is the most frequent cause ones water inside the house may have smells. If you home utilizes well water or cities that use wells for the water supply, raises the likelihood of this happening.

With a water heater temperature setting of 140 degrees or above will assist in lowering the growth of germs inside the water storage tank.

Ways to Remove Smelly Water Odors

The following instructions discuss how to use chlorine bleach to thoroughly clean a water heater.

The electric or gas going to the water heater tank needs to first be turned off.

Next, the cold water supply off that leads to the tank needs to be shut off.

Open the hot water faucet of the kitchen area sink to permit air to get in the tank.

With a a yard hose connected to the storage tank drain valve, drain the water inside the water heater.

Then close the drain valve after it is drained.

The next step is adding the bleach.
If the pipe for the cold water going into the storage tank is a flexible line, unscrew it from the tank. Otherwise, one will likely need to take off the pressure relief valve, which is more involved. For electric water heaters, one of the elements can be removed.

Utilize a funnel to pour bleach into the tank.
Use 5 ounces of bleach per gallon of the tank ability.
So if you have a 50 gallon water heater, you will need 250 ounces of bleach, or about 2 gallons.

Hook the water line or pressure relief valve back up again

Fill the tank back up with water once more.

Shut the hot water faucet of the kitchen area faucet as soon as all the air is out of the line.

Run all the hot water appliances until the smell of bleach is apparent. We want to eliminate the bacteria that are in the water lines also, not only inside the water heater.

Let the water to stay in the tank and water lines undisturbed for 2 to three hours.

Drain the storage tank once again and refill it. This time allow it to remain for at least thirty minutes and just as before drain it.

Fill the tank back up. Turn on all of the hot water fixtures and let them run till the smell of bleach is gone.

For gas water heaters, relight the water heater pilot light. For electric water heaters, turn the electricity on once again.

In addition, by replacing the anode rods, or perhaps the type employed can work as the next video illustrates:

Additionally, by replacing the anode rods, or perhaps the type employed can work as the next video shows:

Odors from Mesa Water Heater

What the Experts Say

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Soquel Creek Water District

How is hydrogen sulfide gas produced in a water heater?

A water heater can provide an ideal environment for the conversion of sulfate to hydrogen sulfide gas. The water heater can produce hydrogen sulfide gas in two ways – creating a warm environment where sulfur bacteria can live, and sustaining a reaction between sulfate in the water and the water heater anode.  Read more…

Minnesota Department of Health

Check out some of our other water heater tips in our blog